As our specialty is turntables, any items on this page THAT ARE NOT TURNTABLES are sold strictly AS-IS, with No warrantees NOR guarantees expressed NOR implied by us, at The Turntable Factory. In some cases, a unit may have been serviced, and may even carry a warranty from the servicer. For the most part, however, these units are sold EXACTLY the way they came in. Each brief description tells the basics, e-mailing us about a certain piece will get a personalized response. We DO guaranty that the item is AS DESCRIBED!!

In the case of any TURNTABLE listed, it will carry our FULL WARRANTY (unless otherwise noted). All of the turntables on this page (except if noted otherwise) are FULLY SERVICED, and ready-to-go

Because some of this equipment is NOT at our fingertips, a picture shown may be of a similar unit, but NOT the EXACT unit. However, be assured that when this is the case, the description will SAY SO.

_________________________________

Proper 3 watt armrest bulb for Empire 598 ~new stock~!

Here's ONE new light bulb for the Empire Troubador series of turntables. It will fit the 598, 598 Series II and 598 Series III. It will NOT fit the Empire models 108, 208, 398 nor 498, those units require an NE-51 neon bulb. It also will not fit the model 698.

This is the CORRECT 117 volt "S6" type bulb. It is 3 watts. As the pictures below show, replacement of this bulb is a "snap"!

$15

_________________________________

10" reel of STILL SEALED Maxell 35-180 10" recording tape.

We have a few, picture is of actual unit,

Per reel: $75

_________________________________

13 VIRGIN REELS RECORDING TAPE~3"~BATT/OP RECORDERS!

Here's 5 reels of virgin 3 1/4" X 1/4" and 8 reels of 3" X 1/4" tape recorder tape. Originally sold for mailing a “voice letter" back in the 60's, they are now ideal for those collectors who have 3" rim-drive and/or battery-operated recorders and either want to use them, or display them with original tape! These 5 are identical, all are branded "AMERICAN" and made by Greentree Electronics, Beverly Hills, California. These "Mail-A-Tape" reels are loaded with 600' of 1/2 mil "tensilized mylar" recording tape. The reels are clear plastic.

$50/all

_________________________________

GARRARD NEW-IN-BOX C-2 CARTRIDGE MOUNT~FITS MANY MODELS

Here's ONE (1) NEW IN THE BOX, old stock Garrard C-2 cartridge mounting assembly. Also known as a "headshell" or "cartridge slide", it comes with an assortment of cartridge mounting screws. The C-2 fits: 40B, SL-55B, SL-65B, SL-72B, SL-95, SL-95B and some others. E-mail with YOUR model, we can tell you if this is the correct one.

$20

_________________________________

GARRARD NEW-IN-BOX C-3 CARTRIDGE MOUNT~FITS ZERO-100~!!

Here's ONE (1) NEW IN THE BOX, old stock Garrard C-3 cartridge mounting assembly. Also known as a "headshell" or "cartridge slide", it comes with an assortment of cartridge mounting screws. The C-3 fits: Zero-100, Zero-100C, Zero 92 and some others. If your Garrard has a small chrome tab sticking out the front of the tonearm, this is YOUR shell! E-mail with YOUR model, we can tell you if this is the correct one.

$20

_________________________________

GARRARD NEW-IN-BOX B-1 TURNTABLE BASE~FITS MANY MODELS

Here's ONE (1) NEW IN THE BOX, old stock Garrard "Official Coordinated Base", model B1 (revision A). This base was the standard base used from 1969 through the early 70s. Made to fit: models 30, 40MK2, 40B, SL-55, SL-55B, SL-65, SL-55B, and MANY others, including: Autoslim, AT-series, even the 42M, 440M and the like.If yours is a 60’s/70’s “small chassis” Garrard, this may be the one you need. This is the base that has a 2-door stowage compartment on the right, and uses the Garrard D-1 dust cover. At this time, we do not have any D1 dustcovers). It is Faux-ebony-&-woodgrain (plastic). E-mail with YOUR model, we can tell you if this is the correct base for your Garrard.

$40

_________________________________

GARRARD NEW-IN-BOX B-2 TURNTABLE BASE~FITS M!ANY MODELS

Here's ONE (1) NEW IN THE BOX, old stock Garrard "Official Coordinated Base", model B2 (revision A). This base was the standard base used from 1969 through the early 70s. Made to fit: models SL-72B, SL-75, SL-75B, SL-95, SL-95B and others, including the 82 and the Zero 100 series, even the Zero 200B and 990B and the like.If yours is a 60’s/70’s “large chassis” Garrard, this may be the one you need. This is the base that has a 2-door stowage compartment on the right, and uses the Garrard D-2 dust cover. At this time, we do not have any D2 dustcovers). It is Faux-ebony-&-woodgrain (plastic). E-mail with YOUR model, we can tell you if this is the correct base for your Garrard.

$40

_________________________________

TECHNICS TURNTABLE CABLE PACKAGE ~AUDIO/AC/GROUND~!!!!!

Here's ONE (1) set of cables for the Technics turntables that have detachable wiring. The kit consists of the proper A/C cord, to plug in the wall, a set of good RCA audio cables, to plug into your amp/receiver and (most importantly) the ground wire necessary to silence the “hum”, and so often found missing on these models. If YOUR Technics rear looks like our picture, here's the kit to make YOUR Technics "whole" again!!!!

$25

_________________________________

GARRARD NEW-IN-BOX LRS-9 45 SPINDLE FOR MODEL LAB-80!!!

Here's ONE (1) NEW IN THE BOX, old stock Garrard LRS9 45 satcking spinle for model Lab 80 and Lab 80MKII. This spindle fits ONLY these two units! This spindle was unsealed from the box just to snap a picture, and to test it in the shop's Lab-80. It stacked and played 10 singles.

Here's an impossible-to-find accessory for YOUR Lab-80, get it while you still can! It IS Garrard OEM, not aftermarket!!

$49

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~